udropship:umarketplace:m2:two-factor-auth
This is an old revision of the document!
Two-Factor Authentication Manual
- Added setting to vendor in admin panel of magento(for platform owner only)
- Go to Sales→Vendors
- Select required vendor and go to Vendor edit form
- Open Preferences tab →Two-Factor Authentication
- Enable – yes – this vendor and VendorUsers for this vendor will have the two-factor authentication enabled. Therefore there will be two-factor auth step on vendor login action.
- Enable – no – this vendor and VendorUsers for this vendor will have the two-factor authentication disabled. .Therefore there will not be two-factor auth step on vendor login action.
- Click on “Save Vendor” button
- Got to System→Cache Management and clean the cache.
- Vendor login with Two-Factor auth enabled like described above:
- Go to vendor portal.
- Login via Vendor credentials
- If Two-Factor auth have been already configured, then two-factor auth form will be shown:
- Enter the code from Google Authenticator Application and press confirm.
- All vendor pages should be available.
- If Two-factor auth have not been configured then on after vendor login the message that configuration was sent to vendor or Vendor user email will be shown.
- Vendor should go into his email provider and click on the provided link to further configure the Two-factor auth
- After page opened the google authentication page with QR code and code will be shown
- Scan the QR with google authenticator application and enter the code provided.
- Press confirm
- Vendor portal page with all menus avaible should be opened.
udropship/umarketplace/m2/two-factor-auth.1695747553.txt.gz · by wtsergo
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
